$ sudo systemctl enable smb Create a Samba userĬreate your Samba user and a password for it: $ sudo smbpasswd -a tuxĪssuming you want to mount your Samba scans on a Linux system, you need to do a few steps.Ĭreate a Samba client credentials file. Start the Samba server service and enable it for restart: $ sudo systemctl start smb My other Samba server, which shares all home networked files, still uses SMB protocol 3 and NTML authentication v2. This is not ideal by any means and has security implications, so I created a separate Samba server dedicated to the scanner use case. For this reason, the Samba share must be configured with the oldest SMB protocol and NTML authentication versions. Unfortunately, the Canon printer won't work with Server Message Block ( SMB) protocols higher than CORE or NTML authentication v2. In the force user line near the end, change the username from tux to your own username. Free online course: RHEL Technical Overview.#NTML AUTHV1 needed for CANON PRINTER SCAN FOLDER #CORE needed for CANON PRINTER SCAN FOLDER Install Samba with the following command: $ sudo dnf -y install sambaĬreate /etc/smb.conf file with the following content: Once this is done, you do not need to use the tool unless you want to make a change.īefore configuring the printer, you must set up a Samba share on your Linux computer or server. The software is required because it is the only way to configure the printer's destination folder location and credentials. Get the Canon toolsĭownload the required Windows Canon Quick Utility Toolbox software from Canon's website. Minor modifications may be necessary for other distributions. I'm using Fedora, so these instructions should work for any RPM-based Linux distribution. Although it's mostly low-level code that many users never knowingly interact with, the software makes it easy to share files over your local network, regardless of what platforms are used. The Samba project is a Windows interoperability suite of programs for Linux and Unix. Specifically, I set up a Samba share to make the scanner available on my network. I was able to solve the scanner's problem with open source. This happened to me recently with a Canon 3-in-1 scanner (the Canon Maxify MB2720). As a result, every now and again, you'll stumble onto a printer or scanner that just doesn't seem to work with your operating system. Decades later, printer and scanner manufacturers continue to reinvent the wheel, ignoring established and universal protocols. ![]() You will be getting an output similar to the one below.The free software movement famously got started because of a poorly designed printer. I exported the output with the “.txt” format, which supports other formats such as “.csv”, “.xml” and “.lst”. Use the following command to scan the given IP address range, export the output and then exit the application. ![]() You can enter your IP range instead of ours. Use the following command to scan a given IP address range. If you’re on the same pinch, here you go. I like to do most of the work from the terminal. 4) How to Use Angry IP Scanner to Scan Network on Linux from Linux Terminal ![]() After scanning the entire network it shows a “Scan Statistics” pop-up window.Ĭlick the Fetchers icon next to the “Start” button to select the one you want from the available fetchers to customize the scan report.
0 Comments
Leave a Reply. |